LanRoamerPROf Tester/AnalyzerUser's Guidewww.jdsu.com/hbn

7Instructions for UseLanRoamerPRO™ powers off automatically after 5 minutes of continuously testing a cable when auto-on powered up the tester. Discon

8To Test Cable from One EndThis can be done immediately after termination of one end of the cable, because no connector or remote is required at the o

9To Test Installed Cable (office jack to patch panel with remote)1) Remove remote unit from main unit by sliding remote towards top of the main unit.

10To Test Coax (tester off or in TEST/PRE-TEST mode)1) Plug RJ45 to F coax adapters into the remote and main units.2) Attach cable to be tested to F

114) To turn tone off, press the MODE button until TURN OFF is displayed, then the SEL button. The tone will turn off automatically after about 2.4 h

12Interpreting Cable Test ResultsThe PASS icon will be on if the cable has all pins properly connected per T568A/B. The FAIL icon will be on if there

13Miswire – A wire or both wires of a pair are not connected to the correct pins at the other end of the cable. In TEST mode, the wire map shows the p

1411111111112222222222333333333344444444445555555555666666666677777777778888888888ShortT568A/B Passing Cable (Unshielded)(1 not twisted with 2; 3 not

15Battery ReplacementWhen the battery low icon is on, the battery should be replaced as soon as practical. The cable testing results will become unrel

16SpecificationsPhysical DimensionsSize: 14. 5 cm x 7.2 cm x 3 cm (5.7" x 2.85" x 1.2") Weight: 176 grams (6.2 oz.) with battery and re

17WarrantyJDSU guarantees that its products will be free of all defects in material and workmanship. This warranty extends for the period of 12 months

18disposal. If the equipment was imported by a reseller whose name or logo is marked on the equipment, then the owner should return the equipment dire

19ShippingBefore returning any product to JDSU, you must first request a Return Merchandise Authorization Number by contacting our Customer Service De

Contact Information:808 Calle PlanoCamarillo, CA 93012USARegional SalesNorth AmericaTel: +1 805 383 1500Fax:+1 805 383 1595Latin AmericaTel: +55 11 55

Warning!Do not attach to energized cables. The LanRoamerPRO™ may be damaged.Caution!Improperly crimped, damaged or un-crimped plugs can damage the ja

1Features• Auto-on and auto-off when testing cables, just plug both ends into tester!• Two-line by 16-character full alphanumeric LCD with icons for

2DescriptionThe LanRoamerPRO™ has an LCD display and four momentary buttons. One remote attaches to the main unit for storage or patch cable testing.

3third line. If a split pair is detected, those pin positions on the second line will be flashing the pin numbers detected from the remote and the spe

4starts a new test, should be pressed whenever a new cable is connected for pre-test. Partial and erroneous results will be displayed until a complete

5one of the four tone sounds provided. The up and down arrows scroll through the pairs and pins that have signal on them. All pins not being driven a

6LanRoamerPRO™ LCD DisplayPASS FAIL CAL SETUP TEST1 2 3 4 5 6 7 8 SIDBeeper OffBatteryLowMain Unit PinNumbersAlphanumericCharactersID NumberIc